Mazda 2 Rear Springs: Specs, Fitment & Common Faults

Genuinely worth confirming first: drivetrain and left/right side both affect which rear spring fits.

Illustration for editorial purposes

Opens live listings in a new tab.

A Part That Fails Quietly, Then Suddenly

On the Mazda 2, rear spring sag tends to creep in gradually over months, with little more than a slightly lower ride height to show for it, before ending suddenly at the coil's end with an audible clunk — worth remembering if one rear corner starts sitting noticeably lower than the other.

Before you buy: drivetrain, trim, and left/right side all affect spring rate and fitment. Always confirm against your VIN before ordering.

OEM Part Number: confirm via VIN — rear coil springs (aftermarket) Kilen 56054 / Monroe SP5019

Accuracy note: Covers the Mazda 2 (DJ 2014-) as listed in the UK aftermarket catalogues. Rear coil springs are sold as a pair for the axle and should be replaced as a pair, because a new spring beside a tired one leaves the car sitting unevenly. The right spring depends on the engine and gearbox, the suspension type (standard, sport or heavy-duty) and, on some cars, the body style. The references below are UK aftermarket catalogue listings for this generation, labelled by brand with the fitment details the catalogue gives; carmakers rarely publish the genuine number against these, so match a genuine spring against your VIN if you want a guaranteed fit. genuinely worth knowing: rear springs are sold in left/right pairs matched to a specific rate marking — confirm the marking on your existing spring rather than assuming from trim alone.

Rear coil springs (aftermarket)	Kilen 56054; Monroe SP5019 (290 mm); KYB K-Flex RA5236 (294 mm); Lesjöfors 4255473
Genuine (OE) numbers quoted	None quoted in the catalogue listings — the genuine spring varies by engine, suspension type and body style, so order it against your VIN
Front-wheel drive, standard rate	Genuinely a different spring from the AWD version below — confirm drivetrain and side before ordering
AWD	A genuinely different spring from the front-wheel-drive version, reflecting the different rear axle layout

The Mazda 2's rear springs should always go in as a pair — fitting one new spring alongside an old, sagged one on the opposite side leaves the car sitting unevenly and biases how it handles.

Mazda 2 Rear Springs: What It Does

On the Mazda 2, supporting the rear end's weight and absorbing the first impact of a bump is the rear coil spring's job, working alongside the shock absorber rather than doing its job for it. A sagged or broken spring drops ride height, can throw off headlight aim, and in serious cases fails an MOT outright.

Find Mazda 2 Rear Springs Here!

Opens live listings in a new tab.

Mazda 2 Rear Springs: Warning Signs, DIY Difficulty & Aftermarket Advice

These are the same regardless of make or model — see our full Rear Springs Guide for symptoms of a failing spring, confirming fitment against your VIN, and OEM vs aftermarket guidance.

More Mazda Rear Springs

The same part, covered across other Mazda models.