Seat Ateca Rear Bumper: Fitment, Sensors & Common Damage
On the Ateca, a real documented case saw reverse camera, lights, and sensors all fail together — traced to wiring cut inside the tailgate hinge from repeated flexing.
Illustration for editorial purposes
Opens live listings in a new tab.
OEM Part Number: confirm via VIN — rear bumper (aftermarket) Diederichs 7480155
| Rear bumper covers (aftermarket) | Diederichs 7480155 (Rear, for vehicles with parking sensors, for vehicles with twin-pipe bumper, primed) |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
A Genuine, Documented Cause Worth Checking First: The Tailgate Hinge Wiring — Seat Ateca Rear Bumper
A genuine, documented pattern worth knowing if your reverse camera, reversing lights, and parking sensors all stop working together (rather than one at a time): this combination points strongly toward a wiring fault at the tailgate hinge itself, where the flexible loom section flexes every single time the boot opens and closes. Over years of use, wires inside this section can fatigue and cut, and because all three functions often share wiring routed through this same flex point, they can fail together in a way that looks like a major electrical fault but actually traces back to this one specific, repairable spot. Opening the tailgate and inspecting the rubber wiring conduit near the hinges for a visible cut or fray is worth doing before assuming a more serious fault.
Seat Ateca Rear Bumper: More Than Just a Plastic Panel
The Seat Ateca's rear bumper carries more hardware than older cars used to — parking sensors, a reversing camera housing, occasionally exhaust trim finishers — which is exactly why even a minor kerb knock can mean more than just ordering a replacement panel.
Seat Ateca Rear Bumper: Watch: Replacing It
The sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
Seat Ateca Rear Bumper: What It Does
Beyond absorbing minor impacts, the rear bumper on higher trims of the Ateca often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Seat Ateca Rear Bumper: Generations, Derivatives & Colour
| Standard trims | Bila White (no-cost solid), Energy Blue (no-cost solid), Reflex Silver, Rhodium Grey |
|---|---|
| Nevada White | Genuinely shares the same paint code (2Y2Y) as Skoda's Moon White — both are cooler, whiter metallics sitting under a VW Group shared platform, and confirmed distinct from the warmer solid Bila White |
| FR/FR Black Edition | Velvet Red and Crystal Black are FR-associated shades; the rear bumper is also styled differently on this trim |
Opens live listings in a new tab.
Seat Ateca Rear Bumper: Common Damage, DIY Difficulty & Aftermarket Advice
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
More Seat Rear Bumper
The same part, covered across other Seat models.