Peugeot Partner Rear Springs: Specs, Fitment & Common Faults

A part that fails quietly, then suddenly — sagging gradually before a sudden, audible failure.

Illustration for editorial purposes

Opens live listings in a new tab.

A Part That Fails Quietly, Then Suddenly

On the Peugeot Partner, the typical failure pattern here is gradual sag over months, barely noticeable beyond a marginally lower stance, followed by a sudden break at the coil's end with an audible clunk. If one rear corner appears to be sitting lower than the other, that's worth investigating.

Before you buy: generation and body style both affect spring rate and fitment. Always confirm against your VIN before ordering.

Peugeot Partner Rear Springs: Watch: Replacing It

🎬 Watch: HowTo: Coil spring and shock absorber replacement on Citroen Berlingo Peugeot Partner

Watch on YouTube ↗

Peugeot Partner Rear Springs reference plate

OEM Part Number: confirm via VIN — rear coil springs (aftermarket) Monroe SP3767 / Sachs 994513

Accuracy note: Covers the Peugeot Partner (2008-2018) as listed in the UK aftermarket catalogues. Rear coil springs are sold as a pair for the axle and should be replaced as a pair, because a new spring beside a tired one leaves the car sitting unevenly. The right spring depends on the engine and gearbox, the suspension type (standard, sport or heavy-duty) and, on some cars, the body style. The references below are UK aftermarket catalogue listings for this generation, labelled by brand with the fitment details the catalogue gives; carmakers rarely publish the genuine number against these, so match a genuine spring against your VIN if you want a guaranteed fit. genuinely worth knowing: rear springs are sold in left/right pairs matched to a specific rate marking — confirm the marking on your existing spring rather than assuming from trim alone.

Rear coil springs (aftermarket)	Monroe SP3767 (standard); Sachs 994513 (standard, 409 mm); Bilstein 36-336050 (standard); Ashika ZCA5769C (393 mm)
Genuine (OE) numbers quoted	None quoted in the catalogue listings — the genuine spring varies by engine, suspension type and body style, so order it against your VIN
Standard rate	Confirm your exact generation and side, since PSA Group used multiple distinct rear spring references across most model generations
Estate/higher-load body style, where applicable	Genuinely a stiffer rear spring rate than the equivalent standard body style, to handle the increased load-carrying capacity

Fitting the Peugeot Partner's rear springs one at a time tends to backfire: pairing a fresh spring with a sagged original on the other side leaves the car sitting unevenly and biases handling to one side.

Peugeot Partner Rear Springs: What It Does

The Peugeot Partner's rear coil spring carries the weight of the car's back end and takes the first hit from any bump, working alongside — not instead of — the shock absorber. Once it sags or breaks, expect a lower ride height, possible headlight aim issues, and in severe cases, an MOT failure.

Find Peugeot Partner Rear Springs Here!

Opens live listings in a new tab.

Peugeot Partner Rear Springs: Warning Signs, DIY Difficulty & Aftermarket Advice

These are the same regardless of make or model — see our full Rear Springs Guide for symptoms of a failing spring, confirming fitment against your VIN, and OEM vs aftermarket guidance.

More Peugeot Rear Springs

The same part, covered across other Peugeot models.