Nissan X-Trail Rear Bumper: Fitment, Sensors & Common Damage
On the X-Trail, a genuinely specific failure point on related models: the camera wire commonly snaps at the boot-to-body flex point.
Illustration for editorial purposes
Opens live listings in a new tab.
OEM Part Number: confirm via VIN — rear bumper (aftermarket) Van Wezel 3375540 / Blic 5506-00-1681950P
| Rear bumper covers (aftermarket) | Van Wezel 3375540 (Rear, without holes for parking sensors, for facelift); Blic 5506-00-1681950P (Rear); Blic 5506-00-1683950P (Rear, from 09.2017) |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
A Genuinely Specific, Real Failure Point Worth Checking First — Nissan X-Trail Rear Bumper
If your reversing camera has stopped working suddenly, this is genuinely worth checking: the wire connecting the camera runs through a rubber pipe or grommet at the point between the boot lid or tailgate and the main body — a location that flexes every time the boot is opened and closed. Over time, this is a well-documented point where the wire can genuinely snap from fatigue. Checking this specific spot and splicing in a new section has resolved this fault directly in documented cases.
It's also genuinely worth knowing that the Body Control Module on related platforms can only be properly reset using Nissan's proprietary Consult diagnostic software — disconnecting the battery genuinely does nothing to reset it.
Nissan X-Trail Rear Bumper: More Than Just a Plastic Panel
What looks like a simple panel swap on the Nissan X-Trail often isn't, since rear bumpers on current cars typically integrate parking sensors, a reversing camera mount, and occasionally exhaust trim — all of which need transferring or replacing alongside the bumper itself.
Nissan X-Trail Rear Bumper: Watch: Replacing It
The sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
Nissan X-Trail Rear Bumper: What It Does
Beyond absorbing minor impacts, the rear bumper on higher trims of the X-Trail often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Nissan X-Trail Rear Bumper: Generations, Derivatives & Colour
| T30 (2001–2007), standard trims | Sunlit Sand, Chrome Silver, Super Black, Athabaska Blue |
|---|---|
| T30 Fat Face Edition (2005, UK-only, 1,998 units) | A genuine UK-exclusive special edition based on the Sport trim, limited to 1,998 units to mark the Fat Face brand's founding year |
| T31/T32 (2007–2021), standard trims | Champagne Silver, Diamond Black, Pearl White, Deep Ocean Blue |
| T33 (2021–present), standard trims | Pearl White, Diamond Black, Champagne Silver, Ceramic Grey |
Opens live listings in a new tab.
Nissan X-Trail Rear Bumper: Common Damage, DIY Difficulty & Aftermarket Advice
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
More Nissan Rear Bumper
The same part, covered across other Nissan models.